PROSPOTfitness SSG Owner's Manual

PROSPOTfitness® Fusion SSG “Space Saving Gym” Featuring Prospot Fitness® Touch Sensor Technology Owner’s Manual Table of Contents Asse

SSG Bench Assembly Diagram 4 Page 10

SSG Fully Assembled Diagram 5 Page 11

SSG Weight Stack Assembly Diagram 6 Page 12

!!Read!! This Page Before Using Your SSG 1. CAUTION: This machine involves the risk of possible injury by its user. 2. THE FOLLOWING RULES

User Instructions for the Prospot Fitness® SSG Do not allow any liquid to be near the machine or spilled on any electrical part. Do not insert an

6. Always maintain control of the movement of the barbell. Do not allow the barbell to swing against the machine frame, as this may cause damage to

Leg Curl: 1. Retrieve the leg developer and turn it so that the locking pin and foam rollers face forward, away from the bench. 2. Slide the square,

Maintenance Program for the SSG The SSG is made of durable materials and has been factory tested to assure proper function and reliability. It is

Trouble-Shooting How the Patented ProSpot System works: Starting from the Computer Brain, a signal is sent from the left & right side, thru the

Trouble-Shooting (con’t) Symptom: Sensor Weight Bar will not unlock. Solution: 1. Remove covers on both sides to gain access to Locking Post Wire

To Get Started: Before assembly, choose a safe location for your Prospot Fitness® SSG. • The SSG has a footprint of approximately 6’x 6’. The bar

SSG Parts List Part # Description QTY Part # Description QTY 1 Weight Stack Weight Plate 2nd plate 1 43 Left Locking Post Cover 1 2 Weight St

SSG Parts List Part # Description QTY Part # Description QTY 85 Lat Leg Hold Down Tube 1 127 Hex Head Bolt M12*65 1 86 Hex Head Bolt M8*20

Warranty & Contact Information Each PROSPOT Fitness® Product comes with a limited parts replacement warranty. Please refer to the actual warran

Assembly Instructions for the SSG Step #1 MAIN FRAME ASSEMBLY 1. Place the (#17, #151) Base Rails opposite each other in the center of the assembly

STEP #2 – FRONT UPRIGHT INSTALATION (con’t) 2. Now feed (#58) Weight Bar Cable Knuckles connected to (#41, #57) Barbell Cables over Double Groove

STEP #3 – WEIGHT STACK INSTALLATION & SENSOR WEIGHT (con’t) 11. Now install (#34) Accessory holders using (#99) bolts, (#90) flat washers & (

STEP #5 – SSG ACCESSORIES & MISC. 1. Now according to diagram #4, install (#129) Plastic Spacing Sleeve & (#62) Foam Roller onto (#85) Lat

SSG Main Frame Assembly Diagram 1 Page 7

SSG Front Upright Assembly Diagram 2 Page 8

SSG Rear Frame Assembly Diagram 3 Page 9